Polaris Ride Command 7" Display Add-On Amplifier Harness - Easily add an external amplifier to most Polaris Ride Commands - Includes both male and female RCA ends- Remote turn on wire

Easily add up to 2 external amplifiers 

Our harness plugs into AMP2, or AMP3 / SUB connector on the factory Ride Command wiring harness.  Requires one harness for each AMP connector.  

One end of our harness plugs into output AMP2, or AMP3 / SUB of the Ride Command Harness and the RCA end plugs into the input side of an external amplifier. 

If you planning on using this harness to add a subwoofer, you will also need to purchase a our subwoofer line driver kit part # RW-RC-RFPEQU.  This installs between this harness and the subwoofer amplifier.  If you do not purchase this subwoofer line driver kit, there will be little to no bass output.  

Our harness also includes one blue remote power wire so the amplifier will turn on when Ride Command is turned on.

Includes both male and female RCA adapters

One harness is required for each amplifier

Please note that this part fits all Polaris units with factory-installed Ride Command with the following exceptions:

• 2020 - 2027 Polaris RZR Pro XP
• Xpedition
• XD 1500
• 2025 - 2027 Ranger XP 1000 / 1000 - All models