• Polaris Ride Command 2-Channel Subwoofer Line Driver - Required if adding an amplifier and subwoofer to Polaris Ride Command 7" Display

    $134.99 $134.99
    Free Shipping!


    Works on all Polaris RZR's, General's, and Ranger's with factory installed Ride Command 7" Display


    This kit amplifies the factory Ride Command AMP3 (subwoofer) connector output so your subwoofer and amplifier will produce much better bass.  


    If you do not install this 2-Channel Line Driver kit, your bass output will be very poor or none at all. 


    This product is not weather resistant except for the remote gain control.  There is plenty of locations under the dash to mount this small box to where it will not get wet so this is not an issue.  You can use zip ties, included 3M tape or screws to hold it in place. The dimensions are 3" x 4.5" X 1" 


    Comes with everything you need to install plus RCA cable with male ends.  


    The yellow wire connects to Constant Power terminal post under the hood (requires battery cables from battery to the power terminal strip under the hood which is not included).  The blue wire connects to the Keyed Power terminal post under the hood, and the black wire connects to Ground.  


    NOTE:  If your amplifier has male inputs, you will need to convert the included RCA cable males ends to female ends (converters not included)  If your amplifier does not have RCA inputs and has speaker line inputs only, you will also need a Line Converter that converts line inputs of the amplifier to RCA ends (not included).